Introduction of three pre-crash car safety systems

As the saying goes, "I often walk by the river, how can I not wet shoes?" Driving outside, accidents are inevitable. The development of the safety system was created to avoid accidents. With the continuous improvement of vehicle safety technology, some manufacturers have begun to introduce a new technology to prevent possible collision problems.

This article refers to the address: http://

Security is a topic that vendors can never finish.

As we all know, the safety system is divided into an active safety system and a passive safety system, but the pre-crash safety system is between the two. The general principle of this system is to monitor the state of the vehicle ahead by the front sensor and automatically respond to the moment before the collision. Measures to reduce the danger. Therefore, it has both the preventive effect of the active safety system and the emergency measures of the passive safety system. In addition, the pre-crash safety system is not a stand-alone device, but a collection of numerous safety systems that ESP and seat belts will be applied when necessary.

●Representative system:

Toyota Pre-CollisionSystem

11.jpg

PCS senses obstacles in front by millimeter wave radar

Toyota's pre-collision safety system is called Pre-CollisionSystem, or PCS for short. It is one of the first brands to equip pre-crash safety systems in production cars. The system was first used on Toyota's Lexus LX and RX models. Its principle is to detect obstacles in front of the head through the millimeter-wave radar hidden in the front of the car to prevent the possibility of frontal collision.

22.jpg

The millimeter wave radar is hidden inside the new crown logo

If the system determines that the possibility of a collision is high, the alarm will sound a reminder to prompt the driver to evade. The brake assist (BA) system will immediately enter the ready state to assist the driver to brake, thus giving the vehicle greater braking force; when the system determines that the collision is about to occur, it will pre-tighten the front and rear driver's seat belt, brake system It will also automatically reduce the speed at the same time.

Mercedes-Benz PRE-SAFE

Mercedes-Benz C-class models have already started using the PRE-SAFE system

The Mercedes-Benz system, which it calls "pre-accident protection", belongs to the first phase of the Mercedes-Benz POE-SAFE (Overall Safety) concept, which divides vehicle safety into three phases: first, active safety The system (PRE-SAFE) reduces the probability of accidents. Secondly, it reduces the damage to the driver in accidents through measures such as high-intensity bodywork. The third stage includes measures such as automatically opening dangerous warning lights after accidents to facilitate rescue work. Smooth development.

The security status judged by the PRE-SAFE system

The PRE-SAFE system is activated within 200 milliseconds once the vehicle is about to collide. The system pre-tightens the seat belt, automatically adjusts the front passenger seat, and closes all windows and sunroofs to prevent foreign objects from colliding into the vehicle.

Volvo: CWAB

Domestic Volvo does not have a CWAB system, only XC60 has

Volvo is known for its safety performance. Of course, such an important safety technology cannot be ignored. The system it invented is called CollisionWarningwithBrakeSupport, which is literally translated into collision warning and automatic braking system. What is embarrassing is that Volvo has just tested the system some time ago, but the result is no effect.

33.jpg

CWAB sensing range

CWAB is similar in principle to the pre-crash safety system introduced earlier. It is worth noting that Volvo has developed a system called CitySafety (city safety) that can automatically brake the vehicle at speeds of up to 30 km/h. Rather than the previous two systems, it only serves as a brake aid.

●Editor's Comments:

Safety is an eternal topic, not just the three listed above, but other manufacturers are also working hard in this regard. Of course, there are still some problems in the current technology that need to be solved. For example, the radar can only sense metal objects, and the brake braking system is not obvious. I believe that after these problems are solved, the pre-crash security system should be widely used.

Robot Speaker:

 

Robot speaker is a kind of speaker unit which is used for multimedia devices.  Multimedia Speakers have loud sound, wide frequency response range and rich bass. 

 

Our main multimedia speakers are full ranges speakers units:

1)    From the diameter: we have speakers in 1" ~ 3".

2)    From the power output, we have speakers of 2W ~ 15W.


 multimedia speaker


multimedia speaker


FAQ

Q1. What is the MOQ?
XDEC: 2000pcs for one model.
Q2. What is the delivery lead time?
XDEC: 20 days for normal orders, 15 days for urgent orders. 
Q3. What are the payment methods?
XDEC: T/T, PayPal, Western Union, Money Gram. 
Q4. Can you offer samples for testing?
XDEC: Yes, we offer free samples. 
Q5. How soon can you send samples?
XDEC: We can send samples in 3-5 days.

Robot Speaker

Robot Speaker ,Bluetooth Robot Speaker,Smart Robot Speaker,Mini Robot Speaker

Shenzhen Xuanda Electronics Co., Ltd. , https://www.xdecspeaker.com